Nationwide courier deliveryPay monthly with MobicredTrack my orderReturns013 004 1508

CCTV power supplies South Africa: how to choose and size a 12V supply for your cameras

Most CCTV faults that look like a camera problem are really a power problem: a picture that drops out at night, cameras that reboot, or a whole system that dies in load-shedding. This guide explains how CCTV power supplies work, how to size one for your cameras, and when a battery-backed supply makes sense. Browse all CCTV power supplies, or read on first.

Three ways to power CCTV cameras

  • A central 12V DC power supply box — one multi-way box with a fused output per camera. This is the standard for analogue (HD-TVI / HD-CVI) systems: neat, easy to fault-find, and one plug for the whole system.
  • A plug-in 12V adapter per camera — fine for one or two cameras near a plug point, but it means a plug at every camera and nothing to protect them.
  • PoE (Power over Ethernet) — IP cameras take power and data down one network cable from a PoE switch or a PoE NVR. No separate power supply is needed at the camera. See our PoE switch guide.

How to size a CCTV power supply

Add up the current (amps) of every camera on the supply, then add about 25% headroom. Use the figure on the camera’s datasheet with the infrared on — cameras draw the most at night, when the IR lights switch on, and that is exactly when an undersized supply starts dropping the picture.

  • 4 cameras — a 4-way 12V supply of about 5A is the usual choice.
  • 8 cameras — an 8- or 9-way box of 8–10A.
  • 16 cameras — a 16- or 18-way box of 10–20A, depending on the cameras.

Long cable runs lose voltage, so a camera at the end of a long run may need a heavier cable or a supply closer to it. Every output should be fused, so one shorted camera does not take the others down.

Battery-backed supplies and load-shedding

A battery-backed 12V supply (often called a power store) charges a small battery and keeps the cameras running when the mains goes off. Remember that the recorder needs power too — keep it on a UPS or the home backup system, otherwise the cameras stay on but nothing is recorded. Our load-shedding backup guide covers the options; backup power equipment is supply only.

Distribution boxes vs open supplies

A distribution box houses the supply, the fuses and the terminal strip in one lockable metal or plastic enclosure — the tidy way to do a permanent installation. A bare switch-mode supply is cheaper and suits a small system inside a cabinet or ceiling box.

Frequently asked questions

Can I use any 12V adapter for a CCTV camera? Only if it supplies enough current for that camera with the IR on, and has the right plug. A weak adapter is the most common cause of a night-time picture that flickers or drops out.

Do IP cameras need a power supply? Not if they are powered by PoE from the NVR or a PoE switch. Check that the switch’s total PoE budget covers all the cameras.

Why do my cameras go off at night? Usually the supply is overloaded when the infrared switches on, or the voltage drops on a long cable run.

Will a power supply keep my cameras on during load-shedding? Only a battery-backed supply will — and the recorder needs its own backup.

Browse all CCTV power supplies or read our CCTV buying guide and CCTV hard drive guide. All prices include VAT, stock is shown live on every product, and orders are delivered anywhere in South Africa. Pay by card, EFT or Mobicred. Send us your number of cameras on WhatsApp (067 354 2867) and we will help you choose the right supply. Capal also installs CCTV systems in the Lowveld.

Leave a Comment

Your email address will not be published. Required fields are marked *

Shopping Basket
Scroll to Top